In order to make your own home Computer network means wiring it with ethernet cable, sockets and also ethernet plugs. It might be a challenging task but this stage by stage guide really should aid the DIY enthusiast build the foundations for a solid network. In the case of ethernet cable the advantages of doing it yourself is that you can custom make the cable lengths for your requirements.
Say you only need a three foot length of ethernet cable, why would you need to buy a twenty foot cable? You wouldn’t unless you wanted to waste money. Follow these steps to wire your own network with ethernet cable.
The first step is to always get the end of the ethernet cable and cut it straight. Follow this by stripping the external casing about an inch from the end. If you want to make this step easier all you have to do is purchase an inexpensive ethernet cable stripper and then all you do is apply some pressure then simply rotate and pull.
When this step is finished, you should have 4 pairs of twisted ethernet cable if you are using Cat 5 cable.
Each pair has one color, one wire being solid the other striped. These colors are usually blue, green, orange and brown. All you need to do is to separate the cables so that the four pairs become eight separate wires. You then should arrange the wires in to the correct pattern for insertion into the plug. By flexing the cables manipulation of the wires is usually much simpler. You’ll find many wiring sequences utilized in Ethernet cable, in most cases diagrams of these may be simply found on the internet.
The plug for the ethernet cable is called an RJ45 connector. If the cables are not of equal length at this point it is usually worth making a straight cut across all of them. When you slide the wires of the ethernet cable into the RJ45 connector make sure they make contact with the copper posts.
Use a crimping tool, or the stripping tool if you have one, to apply pressure to the Ethernet cable and connector to make the connection permanent. This is performed holding the wire in 1 hand and squeezing the crimping tool with reasonable force. This can be accomplished by holding the crimping tool with your dominant hand and the ethernet cable in the other. This stage secures every single wire from the Ethernet cable in its spot and it is a good idea to repeat the process to guarantee all connections have been produced solidly.
Hopefully this guide to creating your very own computer network with Ethernet cable has provided the reader with a good starting point from which to produce your local area networks. With the proper tools and a conscientious mindset it is possible to do the process yourself, saving the cash that would be spent on a network technician.
Learn more about ethernet cable. Stop by Jason Wilson’s site where you can find out all about an ethernet cable splitter and what it can do for you.
|
|